ProForm PFTL39509.0 user manual HOW to Fold and Move the Treadmill, HOW to Move the Treadmill

Page 18

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may permanently damage the treadmill. Next, unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the possibility of injury, do not lift the frame by the plastic foot rails.

Make sure you bend your legs and keep your back straight. As you raise the frame, make sure to lift with your legs rather than your back. Raise the frame about halfway to the vertical position.

2.Move your right hand to the position shown and hold the treadmill firmly. Using your left hand, pull the latch knob to the left and hold it. Raise the frame until the hole in the plat- form cushion is aligned with the latch pin, and then slowly re- lease the latch knob. Make sure that the latch pin is fully inserted into the center of the platform cushion.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of direct sun- light. Do not leave the treadmill in the storage position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert it to the storage position as described above. Make sure that the latch pin is fully in- serted into the center of the platform cushion.

1.Hold one of the handrails and place your other hand on the frame. Place one foot against one of the wheels.

2.Tip the treadmill back until it rolls freely on the wheels. Carefully move the treadmill to the desired location. To re- duce the risk of injury, use extreme caution while mov- ing the treadmill. Do not move the treadmill over an un- even surface. Do not pull back on the frame.

3.Place one foot against one of the wheels, and carefully lower the treadmill until it is resting in the storage position.

Frame

Latch

Engaged

Knob

Platform Cushion

 

Frame

 

Handrails

Wheels

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT QUESTIONS?Model No. PFTL39509.0 Serial No On the WEBTable of Contents Important Precautions Treadmill regularly. Save These Instructions Before YOU Begin Assembly Latch Holes Wire Tie Large Tighten the Bolt yet See the left inset drawing. Identify the twoOuter side of the Frame Spacer facing See the left inset drawing. Identify the outerUpright Wire Side View View from Above Page Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleInsert the key into the console HOW to Turn on the PowerHOW to USE the Manual Mode Start the walking beltMeasure your heart rate if desired HOW to USE a Preset Workout Information Mode HOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useCompatible with GFCI-equipped outlets Top View Problem The walking belt slows when walked onKey and Unplug the Power CORD. Using Walking belt has shifted to the right, turn the leftWorkout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart LIST-Model No. PFTL39509.0 Key No. Qty DescriptionExploded Drawing A-Model No Exploded Drawing B-Model No. PFTL39509.0 R0510A Exploded Drawing C-Model No. PFTL39509.0 R0510A Exploded Drawing D-Model No. PFTL39509.0 R0510A Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents