CONSOLE DIAGRAM
Note: If there is a thin sheet of |
| Key |
plastic on the console, remove it. |
|
|
| ||
|
|
|
Clip
STEP-BY-STEP CONSOLE OPERATION
Note: To prevent damage to the walking platform, always wear clean shoes when using the treadmill.
Before operating the console, make sure that the power cord is properly plugged in (see page 11).
In addition, locate the |
|
|
|
reset/off circuit breaker on |
|
|
|
|
|
| |
the treadmill frame near the |
|
|
|
power cord, and make sure |
|
|
|
| Reset |
| |
that the circuit breaker is in |
|
| |
|
|
| |
|
|
| |
the reset position. |
|
|
|
|
|
|
Next, stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothes. Then, insert the key into the console. After a moment, the display will light. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.
Follow the steps below to operate the console.
If the Start button or the Speed increase button is pressed, the walking belt will begin to move at 1 mph. As you exercise, change the speed of the walking belt as desired by pressing the Speed in- crease and decrease buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. Note: After the buttons are pressed, it may take a moment for the walking belt to reach the selected speed setting.
If one of the numbered speed buttons is pressed, the walking belt will gradually change in speed until it reaches the selected speed setting.
To stop the walking belt, press the Stop button. The elapsed time will begin to flash in the display. To restart the walking belt, press the Start button, the Speed increase button, or one of the numbered speed buttons.
Note: The first time the treadmill is used, observe the alignment of the walking belt, and center the walking belt if necessary (see page 17).
1
Insert the key into the console. | 3 | Change the incline of the treadmill as desired. |
|
2
A moment after the key is inserted, the display will light.
Start the walking belt.
To start the walking belt, press the Start button, the Speed increase button, or one of the speed buttons numbered 1 to 10.
To change the incline of the treadmill, press either of the Incline buttons. Each time a button is pressed, the incline setting will change by 0.5%. Note: After the buttons are pressed, it may take a moment for the treadmill to reach the selected in- cline setting.
12