ProForm 590 rt user manual HOW to Fold and Move the Treadmill, HOW to Move the Treadmill

Page 19

HOW TO FOLD AND MOVE THE TREADMILL

HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the treadmill when you fold it. Remove the key and unplug the power cord. CAUTION: You must be able to safely lift 45 lbs. (20 kg) to raise, lower, or move the treadmill.

1.Hold the metal frame firmly in the location shown by the arrow at the right. CAUTION: To decrease the pos- sibility of injury, do not lift the frame by the plastic foot rails. Make sure to bend your legs and keep your back straight as you raise the frame. Raise the frame about halfway to the vertical position.

2.Raise the frame until the latch knob locks into the storage position. Make sure that the latch knob is locked in the storage position.

To protect the floor or carpet from damage, place a mat under the treadmill. Keep the treadmill out of di- rect sunlight. Do not leave the treadmill in the storage position in temperatures above 85° F (30° C).

HOW TO MOVE THE TREADMILL

Before moving the treadmill, convert the treadmill to the stor- age position as described above. Make sure that the latch knob is locked in the storage position.

1.Hold a handrail and place one foot against one of the wheels.

2.Tip the treadmill back until it rolls freely on the wheelsNever. Carefully move the treadmill to the desired location. move the treadmill without tipping it back. To reduce the risk of injury, use extreme caution while moving the treadmill. Do not attempt to move the treadmill over an uneven surface.

3.Place one foot against a wheel, and carefully lower the treadmill until it is resting in the storage position.

Frame

Frame

Latch

Knob

Handrail

Wheel

19

Image 19
Contents On the WEB QUESTIONS?Model No. PFTL75909.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Pulse sensor is not a medical device Important PrecautionsTreadmill is not in use. See the drawing on Power cord, and switch the reset/off cirTreadmill, and before performing the mainte Cuit breaker to the off position whenBefore YOU Begin Assembly Do not fully fold the Frame yet Make sure that the power cord is unpluggedOvertighten the Locknut the Wheel must Turn freely Page Do not fully tighten the Bolts yet With a second Bolt Spacer 84, 3/8 x 4 Bolt 3/8 Star WasherBolts yet Not fully tighten the Bolts yet105 Console Wire Wire Tie Be careful not to pinch the wires in the Right Handrail Raise the Frame 53 to the position shown HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerMeasure your heart rate if desired Select one of the ten preset workouts. To select an aerobic HOW to USE a Preset WorkoutInformation Mode HOW to USE the Stereo Sound SystemHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Make sure that the gap between the Magnet Reed Switch is about 1/8 in mm. If necProblem The walking belt slows when walked on TopProblem Solution Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches R0909A Part LIST-Model No. PFTL75909.0105 Right Handrail Userʼs Manual 106 Lift Motor Wire Exploded Drawing A-Model No. PFTL75909.0 R0909A Exploded Drawing B-Model No. PFTL75909.0 R0909A Exploded Drawing C-Model No. PFTL75909.0 R0909A Exploded Drawing D-Model No. PFTL75909.0 R0909A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT