ProForm 590 rt user manual Troubleshooting, Compatible with GFCI-equipped outlets

Page 21

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 13). Use only a single-outlet surge suppres-

sor that meets all of the specifications described on page 13. IMPORTANT: The treadmill is not

compatible with GFCI-equipped outlets.

 

 

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c. Check the reset/off circuit breaker located on the

c

 

treadmill frame near the power cord. If the switch

 

protrudes as shown, the circuit breaker has

 

 

tripped. To reset the circuit breaker, wait for five

Tripped

Reset

minutes and then press the switch back in.

PROBLEM: The power turns off during use

 

 

SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The console displays remain lit when you remove the key from the console

SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a

store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off

the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE

INFORMATION MODE on page 18 to turn off the demo mode.

 

PROBLEM: The displays of the console do not function properly

 

 

SOLUTION: a. Remove the key from the console and UNPLUG

a

77

THE POWER CORD. With the help of a second

person, carefully tip the Uprights (77, 79) down.

 

 

There may be three #8 x 2" Screws (24) in the bot-

 

 

tom of the Belly Pan (70). If there are, remove

 

 

them. Note: A Phillips screwdriver with a shaft at

79

70

least 5 in. (13 cm) long is required. Then, raise the

Uprights.

 

 

 

 

24

 

 

24

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model No. PFTL75909.0 Serial No QUESTIONS?Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Pulse sensor is not a medical device Important PrecautionsTreadmill, and before performing the mainte Power cord, and switch the reset/off cirCuit breaker to the off position when Treadmill is not in use. See the drawing onBefore YOU Begin Assembly Make sure that the power cord is unplugged Do not fully fold the Frame yetOvertighten the Locknut the Wheel must Turn freely Page Bolts yet With a second Bolt Spacer 84, 3/8 x 4 Bolt 3/8 Star WasherNot fully tighten the Bolts yet Do not fully tighten the Bolts yet105 Console Wire Wire Tie Be careful not to pinch the wires in the Right Handrail Raise the Frame 53 to the position shown Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerMeasure your heart rate if desired Select one of the ten preset workouts. To select an aerobic HOW to USE a Preset WorkoutInformation Mode HOW to USE the Stereo Sound SystemHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on Reed Switch is about 1/8 in mm. If necTop Make sure that the gap between the MagnetProblem Solution Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencySuggested Stretches R0909A Part LIST-Model No. PFTL75909.0105 Right Handrail Userʼs Manual 106 Lift Motor Wire Exploded Drawing A-Model No. PFTL75909.0 R0909A Exploded Drawing B-Model No. PFTL75909.0 R0909A Exploded Drawing C-Model No. PFTL75909.0 R0909A Exploded Drawing D-Model No. PFTL75909.0 R0909A Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents