ProForm 590 rt Power cord, and switch the reset/off cir, Cuit breaker to the off position when

Page 4

20.

is running. Always remove the key, unplug

25. DANGER: Always unplug the power

Never leave the treadmill unattended while it

cord immediately after use, before cleaning the

 

the power cord, and switch the reset/off cir-

 

treadmill, and before performing the mainte-

 

cuit breaker to the off position when the

nance and adjustment procedures described in

 

treadmill is not in use. (See the drawing on

this manual. Never remove the motor hood un-

21.

page 5 for the location of the circuit breaker.)

less instructed to do so by an authorized ser-

Do not attempt to raise, lower, or move the

vice representative. Servicing other than the

 

treadmill until it is properly assembled. (See

procedures in this manual should be performed

 

ASSEMBLY on page 6, and HOW TO FOLD

by an authorized service representative only.

 

AND MOVE THE TREADMILL on page 19.)

26. This treadmill is intended for in-home use

 

You must be able to safely lift 45 lbs. (20 kg)

only. Do not use this treadmill in a commer-

22.

to raise, lower, or move the treadmill.

cial, rental, or institutional setting.

When folding or moving the treadmill, make

27. Over exercising may result in serious injury

 

sure that the storage latch is holding the

or death. If you feel faint or if you experience

23.

frame securely in the storage position.

pain while exercising, stop immediately and

Never insert any object into any opening on

cool down.

 

the treadmill.

 

24.Inspect and properly tighten all parts of the

treadmill regularly. SAVE THESE INSTRUCTIONS

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents QUESTIONS? Model No. PFTL75909.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEBTable of Contents Important Precautions Pulse sensor is not a medical devicePower cord, and switch the reset/off cir Treadmill, and before performing the mainteCuit breaker to the off position when Treadmill is not in use. See the drawing onBefore YOU Begin Assembly Do not fully fold the Frame yet Make sure that the power cord is unpluggedOvertighten the Locknut the Wheel must Turn freely Page With a second Bolt Spacer 84, 3/8 x 4 Bolt 3/8 Star Washer Bolts yetNot fully tighten the Bolts yet Do not fully tighten the Bolts yet105 Console Wire Wire Tie Be careful not to pinch the wires in the Right Handrail Raise the Frame 53 to the position shown HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeMeasure your heart rate if desired HOW to USE a Preset Workout Select one of the ten preset workouts. To select an aerobicHOW to USE the Stereo Sound System Information ModeHOW to Fold and Move the Treadmill HOW to Move the TreadmillHOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Reed Switch is about 1/8 in mm. If nec Problem The walking belt slows when walked onTop Make sure that the gap between the MagnetProblem Solution Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Part LIST-Model No. PFTL75909.0 R0909A105 Right Handrail Userʼs Manual 106 Lift Motor Wire Exploded Drawing A-Model No. PFTL75909.0 R0909A Exploded Drawing B-Model No. PFTL75909.0 R0909A Exploded Drawing C-Model No. PFTL75909.0 R0909A Exploded Drawing D-Model No. PFTL75909.0 R0909A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT
Top Page Image Contents