ProForm 590 rt user manual Problem Solution

Page 23

PROBLEM:

SOLUTION:

The walking belt is off-center or slips when walked on a. If the walking belt is off-center, first remove the

key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left idler roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is centered.

b. If the walking belt slips when walked on, first re- move the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller bolts clock- wise, 1/4 of a turn. When the walking belt is cor- rectly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walk- ing belt centered. Then, plug in the power cord, in- sert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

a

b

23

Image 23

Contents On the WEB QUESTIONS?Model No. PFTL75909.0 Serial No Mon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MTTable of Contents Pulse sensor is not a medical device Important PrecautionsTreadmill is not in use. See the drawing on Power cord, and switch the reset/off cirTreadmill, and before performing the mainte Cuit breaker to the off position whenBefore YOU Begin Assembly Overtighten the Locknut the Wheel must Turn freely Make sure that the power cord is unpluggedDo not fully fold the Frame yet Page Do not fully tighten the Bolts yet With a second Bolt Spacer 84, 3/8 x 4 Bolt 3/8 Star WasherBolts yet Not fully tighten the Bolts yet105 Console Wire Wire Tie Be careful not to pinch the wires in the Right Handrail Raise the Frame 53 to the position shown PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerMeasure your heart rate if desired Select one of the ten preset workouts. To select an aerobic HOW to USE a Preset WorkoutInformation Mode HOW to USE the Stereo Sound SystemHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Lower the Treadmill for USE Compatible with GFCI-equipped outlets TroubleshootingProblem The power turns off during use Make sure that the gap between the Magnet Reed Switch is about 1/8 in mm. If necProblem The walking belt slows when walked on TopProblem Solution Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches R0909A Part LIST-Model No. PFTL75909.0105 Right Handrail Userʼs Manual 106 Lift Motor Wire Exploded Drawing A-Model No. PFTL75909.0 R0909A Exploded Drawing B-Model No. PFTL75909.0 R0909A Exploded Drawing C-Model No. PFTL75909.0 R0909A Exploded Drawing D-Model No. PFTL75909.0 R0909A Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty