ProForm 397 user manual Assembly, Make sure that the power cord is unplugged, Age the Upright Wire

Page 7

ASSEMBLY

Assembly requires two persons.

Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish assembly.

The underside of the walking belt is coated with high-performance lubricant. After shipping, there may be some lubricant on top of the walking belt or on the shipping carton. This is normal. If there is lubricant on top of the walking belt, wipe it off with a soft cloth and a mild, non-abrasive cleaner.

To identify small parts, see page 6.

Assembly requires the following tools:

the included hex keys one Phillips screwdriver scissors

To avoid damaging parts, do not use power tools.

1. Make sure that the power cord is unplugged.

1

 

Remove and discard the two screws (A) and the

 

shipping bracket (B) from the right side of the

 

Base (74). Then, remove and discard the screws

 

and shipping bracket (not shown) from the left

B

side of the Base.

 

A

 

74

2. Locate the Upright Wire (63) bundled between

2

the Base (74) and the Belly Pan (52). Route the

 

Upright Wire into the Base and out of the indi-

 

cated hole.

 

Press a Base Cap (70) into each side of the

 

Base (74).

 

See the inset drawing. Cut the plastic tie near

 

 

the Upright Wire (63). Be careful not to dam-

 

 

age the Upright Wire.

52

74

 

 

 

Tie

63

Hole

70

Cut

 

 

 

63

 

 

 

7

Image 7
Contents Model No Serial No Treadmill ExerciserTable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyAge the Upright Wire Be careful not to pinch the Upright Wire See the inset drawing. Tie the wire tieTighten the Screws yet Attach the Left Upright not shown Start all four Screws, and then tighten them Upright Wire 63. Start both Screws, and then tighten themPage Page Page HOW to Plug in the Power Cord Operation AND ADJUSTMENTFeatures of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerUpper Display-The upper display Lower right dis- play-The lower rightSelect a preset workout HOW to USE a Preset WorkoutFollow your progress with the displays HOW to USE the Crosswalk Arms Information ModeHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Move the TreadmillSymptom The power does not turn on TroubleshootingSymptom The power turns off during use Symptom The walking belt slows when walked on Symptom The upperbody arms squeak during use Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesKey No. Qty Description Part ListExploded Drawing a Exploded Drawing B Exploded Drawing C Sears, Roebuck and Co., Hoffman Estates, IL DAY Full Warranty