ASSEMBLY
Assembly requires two persons.Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
Assembly requires the included allen wrenches | and your own phillips screwdriver | , | |
rubber mallet | , wire cutters | , and needlenose pliers | . |
To identify small parts during assembly, use the PART IDENTIFICATION CHART in the center of this manual.
1.Make sure that the power cord is unplugged.
1 | 69 |
|
With the help of a second person, carefully raise the | 62 |
| |
Uprights (69) until the treadmill is in the position shown. | 63 |
Insert one of the Extension Legs (63) into the treadmill |
|
as shown. (Note: It may be helpful to tip the Uprights as |
|
you insert the Extension Leg.) Make sure that the |
|
Warning Decal (62) is on the indicated side of the |
|
Extension Leg. |
|
Insert the other Ext ension Leg (63) in the same way.
2.With the help of a second person, carefully lower the treadmill frame and then tip the Uprights (69) down as shown. (Note: It may be helpful to place your foot on an Extension Leg [63] as you tip the Uprights.) Make sure that the Extension Legs remain in the Uprights.
Attach each Extension Leg (63) with two 3/4” Tek Screws (58).
Attach four Base Pads (57) with 3/4” Tek Screws (58) as shown.
Note: One replacement Base Pad (57) may be included. If a Base Pad becomes worn and needs to be replaced, use the replacement Base Pad.
2 |
|
|
|
57 |
|
|
|
58 |
|
|
|
58 | 58 |
|
|
| 57 |
| |
|
|
| |
57 | 63 |
|
|
|
|
| |
58 |
|
|
|
| 58 |
| 69 |
|
| 57 | 63 |
|
|
| |
| 58 |
|
|
5