3.With the help of a second person, raise the Uprights (69) to the vertical Position. Attach the Storage Latch (36) to the left Upright with two 3/4” Screws (2). Remove the
Lock Knob (30) from the Lock Pin (35). Make sure that the Lock Pin Collar (33) and the Spring (32) are on the Lock Pin as shown. Insert the Lock Pin into the Storage Latch and tighten the Lock Knob back onto the Lock Pin.
4.Identify the Right Handrail (72), which has a large hole in the left side. Feed the Wire Harness (42) up into the bracket on the Right Handrail and out of the large hole in the left side. (Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the large hole.) Press a Handrail Cap (76) onto the lower end of the Right Handrail as shown.
Insert the bracket on the Right Handrail (72) into the top
of the right Upright (69) so the Handrail Cap (76) is rest- ing against the Upright. Attach the Right Handrail and the Handrail Cap with three 1” Bolts (37) and two Washers
(38)as shown. Firmly tighten the indicated Bolt but do not tighten the other Bolt yet.
Attach the Left Handrail (not shown) as described above. Note: There is not a wire harness on the left side.
5.Attach the end of the ground wire to the small hole in the side of the Right Handrail (72) with a Silver Ground Screw (75).
3 |
|
| 36 |
30 | 32 |
| |
| 33 |
2 | 35 |
| 69 |
4 |
|
Large | 42 |
Hole |
|
Bracket | 37 |
72 | 38 |
| |
37 | 69 |
| |
Tighten | 38 |
| |
| 76 |
37 |
|
5 |
|
| Ground |
| Wire |
| 75 |
| 72 |
6