6.Place the Console Base (47) on the Right Handrail (72) and the Left Handrail (not shown). Attach the Console Base with four 3/4” Screws (2) (only two Screws are shown). Do not overtighten the Screws.
Insert the Wire Harness (42) through the two indicated
plastic ties on the Console Base (47). Next, | touch the | |
Right Handrail (72) to discharge any static. | Plug the | |
widest connector on the Wire Harness into the widest | ||
connector on the back of the Console (43). | If the connec- | |
tor does n | ot fit easily ,rotate it and then connect it. |
|
Plug the other connector on the Wire Harness into the other connector on the Console.
7. Insert the excess Wire Harness (42) into the large hole in
the side of the Right Handrail (72). | Securely tighten the |
plastic ties on the bottom of the Console Base (47) to | |
prevent the Wire Harness from slipping. | Then, cut off |
the ends of the plastic ties. |
|
Route the Wire Harness (42) through the indicated open- ing in the C onsole Base (47). Attach the Wire Cover to the Console Base (47) with a 1/2” Silver Screw (48).
Tighten two 3/4” Screws (2) into the Console Base (47).
8.Attach a Wheel (66) to the inner side of each Extension Leg (63) with a Wheel Bolt (64) and a Wheel Nut (13) as
shown. Do not overtighten the Bolt. | The Wheel should |
be able to spin freely. |
|
Lift the treadmill frame (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 11), but do not
latch it. Make sure that the frame is centered between the Handrails (not shown). Firmly tighten all of the bolts and screws used in assembly steps 4, 6, and 7.
Then, lower the frame to the floor.
6 | 47 |
|
|
|
| 42 |
|
| Ties |
|
|
2 |
| 43 |
|
|
|
| |
| 72 |
|
|
7 |
|
|
|
Ties | 42 | Opening | 47 |
| |||
|
|
| |
|
|
| 44 |
72 |
|
|
|
|
| 48 | 2 |
|
|
| |
8 |
|
|
|
13 |
| 63 | |
| 64 | ||
| 66 |
| |
|
|
| |
9. Make sure that all parts are properly tightened before you use the treadmill.Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 14). To protect the floor or carpet, place a mat under the treadmill.
7