ProForm 831.23745.1 Start all screws before tightening any, Avoid pinching, Wire Harness, Frame

7. Orient the Rear Frame Cover (23) as shown.	7
While a second person tips the elliptical exercis-
er forward, attach the Rear Frame Cover to the
Base (1) with four M4 x 65mm Screws (91) and
two M4 x 16mm Self-tapping Screws (79).	23
	79
	1
	91
8. Have a second person hold the Upright (6) near	8
the Frame (2) as shown.
Pull the Wire Harness (48) out of the Frame (2)	48
and insert it upward through the Upright (6). Tip:	6
Use a piece of tape or an elastic band to hold
the Wire Harness in place until step 14.
Insert the Upright (6) into the Frame (2). Tip:	2
Start all screws before tightening any of	95
them. Attach the Upright with three M8 x 16mm
	95
Patch Screws (95). Avoid pinching the Wire
	Avoid pinching the
Harness (48) between the Upright and the
	Wire Harness (48)
Frame.
	during this step

9. Apply a generous amount of grease to the Pivot	9
Axle (65) and insert it into the Frame (2).
	86
Orient the two Frame Covers (17) as shown.
Attach the Frame Covers to the Frame (2) with
four M4 x 16mm Screws (86).		2
	17	17
		Grease
		86
		65
	9