ALARM
Up to three alarms may be set to remind you of upcoming events.
1.Press MODE until ALARM appears.
2.Press START/SPLIT to select alarm 1, 2, or 3.
3.Press SET to set selected alarm.
4.Hour digits flash. Press + / – to change hour.
5.Press NEXT and + / – to set minutes, AM or PM (if primary time display is in
6.Press DONE to confirm and exit.
7.Press STOP/RESET to turn Alarm ON or OFF.
TIPS:
•When Alarm is on, d appears in Time display.
•When Alarm sounds, INDIGLO®
•If no button is pushed, alert will cease after 20 seconds and Backup Alarm will activate after 5 minutes.
POD INFORMATIONAL AND ERROR MESSAGES
Blinking antenna icon v – The watch is currently searching for the POD when the wave is blinking. Make sure the POD is on and within range of the watch.
Steady antenna icon V– The watch and the POD are com- municating
Steady jogger icon o – There is no movement detected
Moving jogger icon n– Movement has been detected by the POD and the data is being transmitted to the watch
NO POD DATA – The POD signal was lost. Make sure the POD is powered on and within range. The watch automati- cally powers off after 16 hours of continuous use. At that point, the watch receiver must be turned on again by pressing ON/OFF.
INDIGLO® NIGHT-LIGHT / NIGHT-MODE® FEATURE
1.Press INDIGLO® button to activate
2.Continue to press up to 3 seconds to maintain illumina- tion.
3.Press and hold INDIGLO® button for 4 seconds to activate
4.When
5.To deactivate
WATER & SHOCK RESISTANCE
If your watch is
p.s.i.a. * Water Pressure | |
| Below Surface |
30m/98ft | 60 |
50m/164ft | 86 |
100m/328ft | 160 |
*pounds per square inch absolute
WARNING: TO MAINTAIN
1.Watch is
2.Watch is not a diver watch and should not be used for diving.
3.Rinse watch with fresh water after exposure to salt water.
4.
14 | 15 |