13.The Console (5) requires four 1.5V "D" batteries (not included); alkaJine batteries are recommended. IMPORTANT: If the eHipical exerciser has been exposed to cold tempera- tures, allow it to warm to room temperature before inserting batteries into the Consoleo If you do not do this, the console disptays or other eJectronic components may become
damaged. Remove the battery cover and insert four batteries into the Console. Make sure that
the batteries are oriented as shown at the right. Then, reattach the battery cover.
Note: The Console (5) can be operated with an optional power supply instead of batteries. To purchase a power suppJy, call the
13
14
5
/
Batteries
\
Battery
Cover
14.Have a second person hold the Console (5) near the Upright (6) as shown. Connect the console wire harness to the Wire Harness (48).
Connect the right wire, which has a tag attached, to the Right Controller Wire (111), which has a tag attached. Then, connect the left wire to the Left Controller Wire (110). insert the excess wire downward into the Upright (6).
Attach the Console (5) to the Upright (6) with four M4 x 16mm
15.Attach the Left and Right Upright Covers (10, 64) to the Upright (6) with four M4 x 16mm
Screws (86).
Console Wire Harness 79 48
15
10
86
16.Make sure that aH parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
11