ProForm PFEVEL2786.0 user manual Battery compartment

5.The Console (3) requires four “D” batteries (not included); alkaline batteries are recommended.

Press the tab on the battery cover, and lift off the battery cover. Insert four batteries into the battery

compartment. Make sure that the batteries are oriented as shown by the diagram inside the

battery compartment. Reattach the battery cover.

6.Refer to the inset drawing. Insert the T-handle (4) into the opening in the bottom of the Console (3) as shown. Be careful not to pinch the console wire.

Align the holes in the metal tube on the T-handle with the holes in the bracket on the Console. Tighten two M4 x 12mm Screws (77) into the holes.

While another person holds the Console (3) near the Upright (2), connect the console wire to the Extension Wire (39). Insert the excess console wire and Extension Wire into the Upright.

Attach the Console (3) to the Upright (2) with three M10 x 22mm Button Screws (80) and three M10

Split Washers (54). Be careful to avoid pinching the console wire or the Extension Wire (39).

Snap the bookrack onto the Console (3) in the loca- tion shown.

7.Identify the Left Handlebar (7) and the Left Handlebar Base (8), which are marked with stickers. Attach the Left Handlebar to the Left Handlebar Base with two M6 x 38mm Button Bolts (57) and

two M6 Nylon Locknuts (56).

Attach the Right Handlebar (not shown) to the Right Handlebar Base (not shown) in the same way.

5
		Battery
		Cover
Batteries		3
6		Bookrack
Be careful
not to pinch	3
the console wire
during this step.
	Console
	Wire
		39
3	80
	54	80
	4	54
	80
77		2
Bracket
Tube
77
7
	7
	56
		57
	8

7