RETENTION STRAP/RETAINER | SECTION 11 |
|
|
This Section Includes the Following:
Replacing Battery Box Retainer Bar/Retainer Clip
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.
REPLACING BATTERY BOX RETAINER BAR/RETAINER CLIP (FIGURE 1)
1.Remove the battery box. Refer to REMOVING/INSTALLING BATTERY BOXES in SECTION 9 of this manual.
REPLACING RETAINER CLIP
1.Remove the mounting screw that secures the retainer clip and shock (or rubber element) to the base frame.
2.Remove the existing retainer clip.
3.Position the NEW retainer clip between the shock (or rubber element) and the battery box
WARNING
The Battery Box Retainer Bar/Retainer Clip MUST be fastened securely in place before using the wheelchair. Use Loctite 242 and torque to 160
4.Reinstall the mounting screw that secures the retainer clip and shock (or rubber element) to the base frame. Use Loctite 242 and torque to 160
5.Reinstall the battery boxes. Refer to REMOVING/INSTALLING BATTERY BOXES in SECTION 9 of this manual.
REPLACING RETAINER BAR
1.Remove the two (2) mounting screws and spacers that secure the battery box retainer bar to the base frame.
2.Pull up on the battery box retainer bar to remove it from the base frame.
3.Install the two (2) existing spacers through the mounting holes in the NEW battery box retainer bar.
WARNING
The Battery Box Retainer Bar/Retainer Clip MUST be fastened securely in place before using the wheelchair. Use Loctite 242 and torque to 160
4.Line up the NEW battery box retainer bar and spacers with the mounting holes in the battery box sub frame and the base frame.
5.Reinstall the mounting screws that secure the battery box retainer bar between battery box sub frame and the base frame. Use Loctite 242 and torque to 160
6.Reinstall both battery boxes. Refer to REMOVING/INSTALLING BATTERY BOXES in SECTION 9 of this manual.
RETENTION STRAP/RETAINER
Part No. 1104849 | 81 | 3G Storm Series® Wheelchairs |
