BATTERIES
SECTION 9 | BATTERIES |
|
|
USING BATTERY CHARGERS
1.Perform one (1) of the following:
A.WHEELCHAIRS EQUIPPED WITH
NOTE: The battery charger connector is factory installed on the RIGHT side of the wheelchair. It can be positioned on either side of the wheelchair for user convenience.
NOTE FOR RECLINERS ONLY: If the wheelchair is a recliner, the battery charger connector as well as the limit switch, are factory set on the RIGHT side of the wheelchair. However, they can be positioned on either side for user convenience. The limit switch MUST BE positioned on the same side as the battery charger connector.
B.TORQUE SP EQUIPPED WITH MARK IV RII JOYSTICK - Attach the battery charger connector to the charger port on the FRONT of the joystick.
2.Plug the charger’s AC power cord, or extension, into the grounded 120 VAC wall outlet.
3.Wait until charging is complete.
NOTE: It is advantageous to recharge frequently rather than only when necessary. In fact, a battery’s life is extended if the charge level is maintained well above a low condition.
NOTE: If the batteries need to be charged more often or take longer to charge than normal, they may need to be replaced. Contact an Invacare dealer for service.
WHEELCHAIRS EQUIPPED WITH | WHEELCHAIRS EQUIPPED WITH | ||
MARK IV RII JOYSTICK | |||
Battery Charger Connector | FRONT VIEW OF | Three (3) Pronged Plug | |
JOYSTICK |
| ||
From Battery | Charger Cable | Battery Charger | |
|
| ||
|
|
| |
Charger |
|
| From Battery |
Three (3) |
|
| |
|
| Charger | |
Pronged Plug |
|
| |
|
| Charger | |
|
|
| |
|
|
| Port |
|
| Charger Port | Joystick |
|
|
| |
Battery Charger | Battery Boxes | Battery | |
| Boxes | ||
|
| ||
NOTE: This joystick is available only on the
Torque SP.
Battery Charger Mount Bracket
From
BatteryBase Frame
Charger
Support |
Plate |
Battery Charger |
Port |
FIGURE 7 - CHARGING BATTERIES
3G Storm Series® Wheelchairs | 68 | Part No. 1104849 |
