Invacare Torque SP RWD Replacing Recliner Cable Assemblies Figure, Position Over 105 Relative to

RECLINER SECTION 14

C.Only tighten the two (2) mounting screws and washers that secure the actuator to the gas cylinder pivot block until the actuator does not move.

D.Repeat STEPS 1 and 2 until the wheelchair does not operate when the gas cylinder rod is 3-21/32-inch long.

POSITION OVER 105° RELATIVE TO

Gas Cylinder RodTHE SEAT FRAME

Measures 3-21/32-inches

	Mounting Screws and Washers
	(DO NOT Over-Tighten)
Gas Cylinder Pivot	Actuator
Block

FIGURE 2 - ADJUSTING LIMIT SWITCH

REPLACING RECLINER CABLE ASSEMBLIES (FIGURE 3)

NOTE: There are three (3) different cable lengths depending on back height:

CABLE LENGTH	BACK HEIGHT
Short	18-1/2 and 20-inches
Medium	22 and 24-inches
Long	26-inches

WARNING

Replace ONE (1) recliner cable assembly at a time to avoid injury.

1.Cut the tie wraps that secure the existing recliner cable assembly to the back cane.

2.Remove the pan screw that secures the handle of the existing recliner cable assembly to the back cane.

3.Loosen the jam nut on the gas cylinder rod.

4.Remove the mounting screw, washer, nylon washers and locknut that secure the TOP of the gas cylinder to the mounting bracket on the back cane.

5.Unscrew the gas cylinder from the operator of the existing recliner cable assembly but do not remove the gas cylinder from the pivot block.

6.Remove the operator of the existing recliner cable assembly from the pivot block.

7.Make sure the threads of the gas cylinder rod are flush with the inside of the pivot block.

8.With the operator of the NEW recliner cable assembly on the inside of the recliner seat frame, line up the mounting hole in the operator of the new recliner cable assembly with the gas cylinder rod.

RECLINER

Part No. 1104849 111 3G Storm Series® Wheelchairs