Invacare Arrow RWD Installing Group 24 Components Figure, Wheelchairs Equipped with Vent Tray

RWD WHEELCHAIRS

SECTION 15 RWD WHEELCHAIRS

Washer

Locknut

Battery Mount

Bracket

Spacer

Mounting Screws

*Rubber Element
(or Shock Assembly)	Base Frame

*NOTE: Illustration depicts rubber element. Battery Mount Brackets remove in the same manner for the shock assembly.

FIGURE 3 - REMOVING 22NF COMPONENTS

INSTALLING GROUP 24 COMPONENTS (FIGURE 4)

1.Line up the mounting holes in the front of the NEW battery box sub-frame and the NEW wiring harness w/bracket with the mounting holes in the base frame.

2.Install the two (2) mounting screws through the wiring harness w/bracket, battery box sub-frame, and base frame.

3.Install the locknuts onto mounting screws. Torque to 160 in-lbs.

4.Perform one (1) of the following:

A. WHEELCHAIRS EQUIPPED WITH VENT TRAY

WARNING

The Battery Box Retainer/Retainer Clip MUST be fastened securely in place before using the wheelchair. Use Loctite 242 and torque to 160 in-lbs.

￿Position the retainer clip between the NEW battery box sub-frame and the top of the rubber element or shock assembly making sure the retainer clip mounting hole is towards the bottom and the closed end of the clip is against the battery box retainer bar.

NOTE: Make sure the closed end of the battery box retainer clip is pointing up.

￿Install the mounting screw that secures the retainer clip to the battery box sub-frame. Use Loctite® 242 and torque to 160 in-lbs.

￿Line up the NEW battery box retainer bar and spacers with mounting holes in the base frame (FIGURE 5).

￿Reinstall the mounting screws that secure the battery box retainer bar to the base frame. Use Loctite 242 and torque to 160 in-lbs (FIGURE 5).

3G Storm Series® Wheelchairs 122 Part No. 1104849