Invacare Arrow RWD, Torque SP RWD, Ranger X RWD service manual 107

ELECTRONICS SECTION 13

REMOVING GB CONTROLLER (WHEELCHAIRS EQUIPPED WITH 2ND GENERATION POWERED SEATING SYSTEMS) (FIGURE 5)

1.Remove the battery boxes. Refer to REMOVING/INSTALLING THE BATTERY BOXES in SECTION 9 of this manual.

2.Remove the controller shroud (if applicable).

3.Remove the TRCM controller (if applicable). Refer to REPLACING THE TILT AND RECLINE CONTROL MODULE (TRCM) in Tilt and Recline Service Manual, part number 1090208.

4.Remove the 5/16-18 x 1-inch hex head cap screw that secures the jumper cable and controller bracket to the base frame.

5.Remove the 5/16-18 x 1-inch hex head cap screw that secures the controller bracket to the base frame.

6.Remove the 10-32 x 1/2-inch mounting screw and two (2) lockwashers that secures the front of the GB controller and jumper cable to the controller bracket.

7.Remove the two (2) 8-32 x 1/2-inch mounting screws that secure the rear of the GB controller to the controller bracket.

INSTALLING GB CONTROLLER (WHEELCHAIRS EQUIPPED WITH 2ND GENERATION POWERED SEATING SYSTEMS) (FIGURE 5)

1.Secure the rear of the GB controller to the controller bracket with two (2) of the NEW 10-32 x 1/2-inch mounting screws. Securely tighten.

2.Secure the front of the GB controller and one end of the jumper cable to the controller bracket with one (1) of the NEW 10-32 x 1/2-inch mounting screw and lockwasher. Securely tighten.

3.Secure one side of the controller bracket to the base frame with one (1) of the NEW 5/16-18 x 1-inch hex head cap screws. Securely tighten.

4.Secure the other side of the controller bracket and opposite end of jumper cable to the base frame one (1) of the NEW 5/16-18 x 1-inch hex head cap screws. Securely tighten.

5.Reinstall the TRCM controller (if applicable). Refer to REPLACING THE TILT AND RECLINE CONTROL MODULE (TRCM) in Tilt and Recline Service Manual, part number 1090208.

6.Reinstall the controller shroud (if applicable).

7.Reinstall the battery boxes. Refer to REMOVING/INSTALLING THE BATTERY BOXES in SECTION 9 of this manual.

ELECTRONICS

Part No. 1104849 107 3G Storm Series® Wheelchairs