ELECTRONICS
SECTION 13 | ELECTRONICS |
|
|
This Section Includes the Following:
Repositioning MKIV Joystick - Van Seat Models
Removing/Installing the MKIV Controller
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.
REPOSITIONING MKIV JOYSTICK - VAN SEAT MODELS (FIGURE 1)
1.Turn the lever on the adjustment lock to release the adjustment lock from joystick mounting tube.
2.Remove the joystick mounting tube from wheelchair.
3.Remove the three (3) hex bolts, spacers and locknuts that secure joystick mounting bracket to armrest plate.
4.Remove the phillips screws that secures the front of the armrest pad to the armrest plate.
5.Remove the phillips screw that secures the rear of the armrest pad and armrest insert to the armrest plate.
6.Remove the armrest pad from the armrest plate.
7.Remove the lug bolt, washers and locknut that secure the existing armrest plate to the armrest weldment.
8.Repeat STEPS
9.Position armrest plate with joystick mounting holes on desired side of armrest weldment and secure with lug bolt, washers and locknut. Refer to FIGURE 1 for correct hardware orientation.
10.Position armrest plate without joystick mounting holes on opposite side of the armrest weldment and secure with lug bolt, washers and locknut. Refer to FIGURE 1 for correct hardware orientation.
Armrest Plate | Lug Bolt (STEPS 7, 9) | ||
Armrest Insert |
|
| Locknuts |
|
|
| |
|
|
| (STEPS 3,16) |
Phillips Screw |
|
|
|
(STEPS 5, 13) |
|
|
|
Locknut |
|
|
|
(STEPS 7, 9) |
|
| Armrest Pad |
|
|
| |
Washer |
|
|
|
(STEPS 7, 9) |
|
|
|
Hex Bolts |
|
| Phillips |
(STEPS 3, 16) |
|
| Screws |
|
|
| (STEPS 4, |
|
| Armrest | 14) |
|
|
| |
|
| Weldment | |
Joystick Mounting |
|
| Spacers |
Bracket | Washers | (STEPS 3, 16) | |
(STEPS 3, 16) | (STEPS 7, 9) |
| |
FIGURE 1 - REPOSITIONING MKIV JOYSTICK - VAN SEAT MODELS
3G Storm Series® Wheelchairs | 100 | Part No. 1104849 |
