SEAT FRAME
SECTION 6 | SEAT FRAME |
|
|
INSTALLING/REMOVING ASBA SUBASSEMBLY AND/OR COMPONENT REPLACEMENT (FIGURE 6)
CONVERTING FROM ASBA TO STANDARD SEAT FRAME OR VAN SEAT
NOTE: This section must be performed in conjunction with a starting procedure.
1.Remove the four (4) mounting screws that secure the two (2) support brackets of the ASBA subassembly to the seat mounting plates.
2.To complete conversion, refer back to the starting procedure to complete the desired change.
CONVERTING FROM STANDARD SEAT FRAME OR VAN SEAT TO ASBA
NOTE: This section must be performed in conjunction with a starting procedure.
NOTE: When converting the seat frame, you will need a seat pan, seat cushion, back upholstery and spreader bar (if applicable). Spreader bars are only required on seat depths of greater than
1.Secure both support brackets to the seat mounting plates with four (4) mounting screws and locknuts. Torque mounting screws to 156
2.Secure the center frame to the support brackets with four (4) mounting screws, locknuts, and spacers. Torque to 156
3.Insert the side frame into the center frame and secure with mounting screw, coved spacer, spacer, and locknut. Torque to 75
COMPONENT REPLACEMENT
1.Perform the instructions outlined in PREPARATION FOR REMOVING/INSTALLING SEAT FRAME (STANDARD FRAME, ADJUSTABLE FRAME, AND VAN SEAT) in this section of the manual.
NOTE: Note the mounting hole position of the current side frame(s) for proper installation of the NEW side frame(s).
2.Remove the two (2) mounting screws, coved spacers, spacers, and locknuts that secure the side frame to the center frame.
3.Perform one (1) of the following:
A.If center frame needs replaced, repeat STEP 2 for opposite side frame and proceed to STEP 4.
B.If opposite side frame needs replaced, repeat STEP 2, then proceed to STEP 6. Otherwise proceed to STEP 6.
3G Storm Series® Wheelchairs | 38 | Part No. 1104849 |
