Invacare Arrow RWD, Torque SP RWD, Ranger X RWD REMOVING/INSTALLING Seat Stop Screws Figure

SECTION 7 BASE FRAME

4.Remove the two (2) mounting screws that secure the battery charger connector to the mount bracket.

5.Remove battery charger connector from mount bracket.

6.Remove the mounting screw which secures the battery charger mount bracket to the T-nut located in the channel of the base frame.

BASE FRAME

7.Replace battery charger mount bracket and secure to base frame with existing mounting screw.

NOTE: To replace the Battery Charger Bracket T-Nut, perform STEPS 3-13 in

REPLACING SEAT SUPPORT BRACKET T-NUTS in this section of the manual.

8.Secure the battery charger connector to the mount bracket with the EXISTING two (2) mounting screws. Tighten securely.

9.Reverse STEP 2.

Mounting Screw

Battery	Battery
	Charger
Charger
	Connector
Mount
Bracket
	T-Nut
Base
Frame

FIGURE 4 - REPLACING BATTERY CHARGER BRACKET AND T-NUT

10.Perform the instructions outlined in PREPARATION FOR REMOVING/INSTALLING SEAT FRAME (STANDARD FRAME, ASBA, AND VAN SEAT) in SECTION 6 of this manual.

REMOVING/INSTALLING SEAT STOP SCREWS (FIGURE 5)

NOTE: The front seat stop screw should only be removed if replacing a T-nut for either the seat support bracket or the battery charger mount bracket. The rear seat stop screw should never be removed.

1. Unthread seat stop screw from base frame.

WARNING

The seat stop screws must be in place before operation of your power wheelchair. Ensure the seat support bracket is positioned between both seat stop screws.

2.When reinstalling the front seat stop screw, ensure the seat support bracket is located in-between both seat stop screws. Use loctite 242 and tighten securely.

Seat Support Bracket

Base

Frame

Rear Seat

Stop Screw

Front Seat Stop Screw

FIGURE 5 - REMOVING/INSTALLING SEAT STOP SCREWS

3G Storm Series® Wheelchairs 50 Part No. 1104849