SECTION 6 | SEAT FRAME |
|
|
CHANGING SEAT DEPTH
STANDARD SEAT FRAME
NOTE: Review the chart below. This will determine the components needed to obtain the desired seat depth.
SEAT FRAME
1.Find current seat depth in left hand column in the chart.
2.Follow that row to right under seat frame components.
3.Verify and note the components of the current seat depth.
4.Repeat STEPS
5.Compare existing components of the current seat depth and the required components for the desired seat depth.
6.Perform one (1) of the following:
| SEAT FRAME COMPONENTS | ||
| CJ BACK |
| SEAT |
SEAT | BRACKETS | SEAT | FRAME |
DEPTH | REQUIRED | PAN | DEPTH |
|
|
| |
to | YES | ||
|
|
| |
|
|
|
|
NO | |||
|
|
|
|
NO | |||
|
|
|
|
NO | |||
|
|
|
|
NO | |||
|
|
|
|
NO | |||
|
|
|
|
NO | |||
|
|
|
|
NO | |||
|
|
|
|
A.If the current seat depth and
the desired seat depth is within the 12 to
B.If the desired change only requires a NEW seat pan, refer to REMOVING/ INSTALLING SEAT PAN in this section of the manual.
C.For all other seat depth changes, perform the following:
PREPARATION FOR REMOVING/INSTALLING SEAT FRAME (STANDARD FRAME, ASBA, AND VAN SEAT) in this section of the manual.
Perform one (1), two (2), or all three (3) of the procedures listed below depending on the components required for the desired seat depth determined from STEPS
REMOVING/INSTALLING CJ BACK BRACKETS in SECTION 8 of this manual.
REMOVING/INSTALLING STANDARD SEAT SUBASSEMBLY in this section of the manual.
REMOVING/INSTALLING SEAT PAN in this section of the manual.
After completing the procedure(s) listed above, perform the steps outlined in
PREPARATION FOR REMOVING/INSTALLING SEAT FRAME (STANDARD FRAME, ADJUSTABLE FRAME, AND VAN SEAT) to complete the desired seat depth change.
3G Storm Series® Wheelchairs | 32 | Part No. 1104849 |
