WHEELS/MOTORS
SECTION 12 | WHEELS/MOTORS |
|
|
HEAVY DUTY GEARLESS/BRUSHLESS MOTOR (FIGURE 11)
Removing.
1.Remove the battery boxes. Refer to REMOVING/INSTALLING BATTERY BOXES in SECTION 9 of this manual.
2.Unthread the mounting screws that secure the wiring harness connector (not shown) to the motor.
3.Unplug the wiring harness connector (not shown) from the motor.
4.Remove the drive wheel from the wheelchair. Refer to REMOVING/INSTALLING THE RIM AND/OR TIRES in this section of the manual.
5.Note the mounting position of the motor on the suspension arm before removing the motor.
6.Remove the cotter pin from the motor lock lever rod.
7.Disengage motor lock lever rod from the brake release lever located on the gearless/brushless motor.
8.Remove the two (2) upper mounting screws that secure the gearless/brushless motor, fender bracket and spacer to the suspension arm.
9.Remove the two (2) lower mounting screws and washers that secure the gearless/ brushless motor and spacer motor to the suspension arm.
10.Remove the gearless/brushless motor and fender bracket from the suspension arm.
Installing.
1.Position the new/existing motor onto the suspension arm in the mounting position noted in STEP 5 of REMOVING THE MOTOR in the procedure above.
2.
3.Secure the gearless/brushless motor, spacer and fender bracket to the suspension arm with existing two (2) upper mounting screws, two (2) lower mounting screws and two (2) washers. Torque all four (4) mounting screws to 13
4.Engage the motor lock lever rod to the brake release lever on the motor and secure with the existing cotter pin.
5.Install the drive wheel to the wheelchair. Refer to REMOVING/INSTALLING THE RIM AND/OR TIRES in this section of the manual.
6.Plug the wiring harness connector (not shown) to the motor.
7.
8.Install the battery boxes. Refer to REMOVING/INSTALLING BATTERY BOXES in SECTION 9 of this manual.
3G Storm Series® Wheelchairs | 94 | Part No. 1104849 |
