RECLINER

SECTION 14

RECLINER

 

 

9.Secure limit switch sensor to the seat frame with the two (2) mounting screws and washers.

10.Secure the wire retainer onto the INSIDE of the seat frame with the mounting screw.

11.Tie wrap the limit switch wire to the seat frame.

12.Adjust the limit switch. Refer to ADJUSTING LIMIT SWITCH in this section of the manual.

 

 

Mounting Screws

Limit Switch

 

 

(DO NOT Over Tighten)

Sensor

 

 

 

Actuator

 

Washers

 

Tie Wraps

Mounting Screws

 

 

Mounting

(DO NOT Overtighten)

 

 

Screws

 

 

 

 

Wire

Seat

 

 

Retainer

Frame

 

 

 

Limit Switch

Gas Cylinder

Mounting Screw

Pivot Block

Sensor

 

(DO NOT Overtighten)

 

Actuator

 

 

Washers

 

FIGURE 1 - POSITIONING LIMIT SWITCH

ADJUSTING LIMIT SWITCH (FIGURE 2)

WARNING

NEVER operate the wheelchair while in any recline position over 105o RELATIVE TO THE SEAT FRAME. If the limit switch does not stop the wheelchair from operating in a recline position greater than 105o RELATIVE TO THE SEAT FRAME, do not operate the wheelchair. Adjust the limit switch BEFORE using the wheelchair, otherwise injury or damage can occur.

1.Recline the back of the wheelchair until the gas cylinder rod measures 3-21/32 of an inch.

2.Turn the power of the joystick to the ON position.

NOTE: ALL segments of the bar graph on the joystick should start to flash on and off and the wheelchair should not operate.

3.IF the wheelchair operates, proceed to the following steps to adjust the actuator on the gas cylinder pivot block:

A.Loosen, but do not remove, the two (2) mounting screws and washers that secure the actuator to the gas cylinder pivot block.

B.Slide actuator UP (towards top of the wheelchair).

CAUTION

DO NOT over tighten the mounting screws that secure the actuator to the pivot block. Damage to the actuator will occur.

3G Storm Series® Wheelchairs

110

Part No. 1104849

Page 110
Image 110
Invacare Arrow RWD, Torque SP RWD, Ranger X RWD service manual Adjusting Limit Switch Figure, Section Recliner