GENERAL GUIDELINES
SECTION 1 | GENERAL GUIDELINES |
|
|
This Section Includes the Following:
Repair or Service Information
Operating Information
Label Location
Warning/Caution Label Location
Shipping Tie Down Restraints
REPAIR OR SERVICE INFORMATION
Setup of the Electronic Control Unit is to be performed ONLY by individuals certified by Invacare. The final tuning adjustments of the controller may affect other activities of the wheelchair. Damage to the equipment could occur under these circumstances. If
OPERATING INFORMATION
GENERAL WARNINGS
Professionals of the healthcare field or other persons should only make performance adjustments fully conversant with this process and the wheelchair operator’s capabilities. Incorrect settings could cause injury to the driver, bystanders, damage to the chair and to surrounding property.
After the wheelchair has been set up/adjusted, check to make sure that the wheelchair performs to the specifications entered during the setup procedure. If the wheelchair does NOT perform to specifications, turn the wheelchair OFF immediately and reenter setup specifications. Repeat this procedure until the wheelchair performs to specifications.
DO NOT leave the power button ON when entering or exiting your wheelchair.
Avoid storage or use near external flames or combustible products.
ELECTRICAL Grounding Instructions:
DO NOT, under any circumstances, cut or remove the round grounding prong from any plug used with or for Invacare products. Some devices are equipped with
3G Storm Series® Wheelchairs | 12 | Part No. 1104849 |