
WHEELS/MOTORS | SECTION 12 |
|
|
REMOVING/INSTALLING THE MOTOR
CONVENTIONAL MOTOR WITH GEARBOX (FIGURE 9)
Removing.
1.Disconnect the right and/or left motor connector from the controller.
2.Remove the two (2) allen screws and washers that secure the motor to the gearbox.
CAUTION
DO NOT damage the motor/gearbox coupling.
3. Carefully pull the motor away from the gearbox.
Installing. |
| |
1. Perform the following: |
| |
A. Inspect the coupling for wear and | Motor | |
| damage. If damage is evident, | Connector |
|
| |
| replace coupling. |
|
B. | Install coupling onto gearbox input |
|
| shaft inserting coupling drive plate | Motor Connector |
| onto slot on shaft. |
|
C. Carefully align motor and coupling | Motor | |
| ||
| and place motor against gearbox. | Coupling |
D. With motor against gearbox, turn | Gearbox | |
| gearbox drive shaft until the | |
| Allen | |
| coupler seats into gearbox. | |
| Screw | |
NOTE: When properly aligned, motor will be | Washer | |
seated into gearbox. | Slots* | |
|
| |
E. | Install two (2) allen screws. |
|
| Use Loctite 242, tighten allen |
|
| screws evenly and then torque to | *NOTE: The slots on coupling of motor, the |
| 75 | slots on the coupling and the slots on the |
2. Reconnect right/left motor connector | gearbox must line up for proper installation | |
| ||
to controller. | FIGURE 9 - REMOVING/ | |
|
| INSTALLING THE MOTOR - |
CONVENTIONAL MOTOR/
GEARBOX
WHEELS/MOTORS
Part No. 1104849 | 91 | 3G Storm Series® Wheelchairs |