Invacare Torque SP RWD, Ranger X RWD Installing Wheel Lock Bracket Onto Wheelchair Figure

WHEELS/MOTORS SECTION 12

INSTALLING WHEEL LOCK BRACKET ONTO WHEELCHAIR (FIGURE 5)

NOTE: This SECTION only pertains to wheelchairs with the conventional motor and gearbox. On wheelchairs with the gearless/brushless motor, the wheel lock bracket is not required.

1.Remove the two (2) mounting screws closest to the large wheel that secure the gearbox to the suspension arm.

2.Line up mounting holes in the wheel lock mounting bracket with the gearbox mounting holes in the suspension arm.

3.Apply Loctite 242 to the two (2) mounting screws.

4.Reinstall the two (2) mounting screws into the mounting holes of the wheel lock mounting bracket and gear box and torque to 75 in-lbs.

5.Repeat STEPS 1-4 for opposite wheel lock bracket.

6.Adjust the wheel locks. Refer to ADJUSTING WHEEL LOCKS in SECTION 9 of the Owner’s Manual, part number 1104782 or 1123757.

Mounting	Wheel Lock
Screws	Mounting
	Bracket
Gearbox
	Suspension
	Arm

FIGURE 5 - INSTALLING WHEEL LOCK BRACKET ONTO WHEELCHAIR

WHEELS/MOTORS

Part No. 1104849 87 3G Storm Series® Wheelchairs