SEAT FRAME | SECTION 6 |
|
|
SEAT ANGLE ADJUSTMENT (FIGURE 10)
NOTE: The angle of the seat is factory set providing the user with a 5o seat dump. This angle can be changed by adjusting either the front or back of the seat mount plate to obtain any angle between 0o or 10o seat dump.
NOTE: There are three (3) heights of seat mounting plates; low, medium, and high.
LOW HEIGHT |
| MEDIUM HEIGHT |
| HIGH HEIGHT |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1.To obtain a 0o seat dump (DETAIL “A”):
A.Loosen the two (2) mounting screws that secures the seat mount plate to the seat support bracket.
B.Loosen the two (2) mounting screws that secures the remaining seat mount plate to the seat support bracket.
C.Adjust the seat mount plates so that the rear mounting screws are positioned at the bottom of the rear slots.
SEAT FRAME
D. Adjust the seat mount plates so | |
| that the front mounting screws are |
| positioned at the top of the front |
| slots. |
E. | Securely tighten all four (4) mounting |
| screws. Torque to 156 |
2. To obtain a 10o seat dump (DETAIL “A”): | |
A. Loosen the two (2) mounting | |
Rear of Seat Frame
Mounting | DETAIL “A” |
| |
Screw |
|
screws that secure the front of the |
seat frame to the seat mount plate. |
B. Position the mounting screws at |
Medium Height Seat Mount Plate
Front of
Seat Frame
the bottom of the front slot. |
C. Securely tighten both mounting |
screws. Torque to 156 |
Mounting Screw
FIGURE 10 - SEAT ANGLE
ADJUSTMENT
Part No. 1104849 | 45 | 3G Storm Series® Wheelchairs |
