
BATTERIES
SECTION 9 | BATTERIES |
|
|
22NF BATTERIES IN SINGLE BATTERY BOX (FIGURE 5)
NOTE: Note polarity of white battery cable (jumper) battery terminal ends.
Disconnecting.
1.Remove battery terminal cap(s) from battery terminal(s) ends. Refer to DETAIL “A” in FIGURE 5.
2.Disconnect WHITE battery cable (jumper) NEGATIVE N terminal end from
NEGATIVE
3.Disonnect NEGATIVE
4.Disonnect POSITIVE (+) RED battery cable on battery box top from POSITIVE (+) battery terminal/post of front battery.
Connecting.
1.Remove battery terminal cap(s) from battery terminal(s) ends. Refer to DETAIL “A” in FIGURE 5.
2.Connect WHITE battery cable (jumper) NEGATIVE N terminal end to NEGATIVE
3.Place battery top upside down on top of rear battery.
4.Connect NEGATIVE
5.Position battery box top right side up and rotate outward toward right to expose POSITIVE (+) battery terminal/post of front battery.
6.Connect POSITIVE (+) RED battery cable on battery box top to POSITIVE (+) battery terminal/post of front battery.
7.Replace battery terminal cap(s) onto battery cable terminal end(s).
8.Rotate top toward left into position. Secure in place.
9.Install the battery box into the wheelchair. Refer to REMOVING/INSTALLING BATTERY BOXES in this section of the manual.
NOTE: New Battery(ies) MUST be fully charged BEFORE using, otherwise the life of the battery(ies) will be reduced.
10.If necessary, charge the battery(ies). Refer to CHARGING BATTERIES in this section of the manual.
3G Storm Series® Wheelchairs | 64 | Part No. 1104849 |