6.Identify the Right Pedal (63), which has an “R” mold- ed into its bottom surface, and the Right Pedal Tube (64), which is marked with a sticker.
Attach the Right Pedal (63) to the Right Pedal Tube (64) with two M8 x 1 9/16” Hex Bolts (41), two M8 Washers (52), and two M8 Nylon Locknuts (57).
Attach the Left Pedal (not shown) to the Left Pedal Tube (not shown) in the same way.
7.Apply a thin film of the included grease to the parts shown at the right.
Slide a Wave Washer (50) onto the axle on the Right Crank Arm (15). Next, slide the Right Pedal Tube (64) onto the axle. Attach the Right Pedal Tube with an M8 x 3/4” Hex Bolt (26) and a Nylon Bushing (32).
Attach the Right Pedal Tube (64) to the right Handlebar Leg (5) with an M8 x 2 1/2” Hex Bolt (40), an M6 Washer (55), and an M6 Nylon Locknut (56).
Repeat this step to attach the Left Pedal Tube (not shown) to the left side of the elliptical exerciser.
8.Insert a Plastic Sleeve (16) into the top of the right Handlebar Leg (5). Then, insert a Handlebar (6) into the right Handlebar Leg. Align the holes in the Handlebar with the holes in the Handlebar Leg. Attach the Handlebar with two M6 x 5/8” Pocket Screws (46), two M6 Arc Washers (39), and two M6 Nylon Locknuts (56).
Attach the other Handlebar (6) to the left Handlebar Leg (5) in the same way.
6 | 41 |
|
|
| |
63 |
| |
|
| 64 |
|
| 52 |
| 52 | 57 |
|
| |
7 |
| 5 |
|
| |
|
| Grease |
|
| 56 |
|
| 55 |
|
| 40 |
|
| Grease |
Grease |
| |
15 | 64 |
|
50 |
| |
|
| |
Grease | 32 |
|
| 26 |
|
8 |
|
|
6 |
|
|
|
| 6 |
5 |
| 16 |
|
| |
| 39 | 56 |
|
| 5 |
| 46 |
|
| 39 |
|
9.Make sure that all parts of the elliptical exerciser are properly tightened. Place a mat under the elliptical exerciser to protect the floor or carpet from damage.
7