Star Trac S-TBTX manual Maintenance Mode, Tim

TIM

WGT

Lxx

LOE LOI

5

1(lb)

1(kg)

N/A

OFF

001

99	99
500 (lb)	155 (lb)
226 (kg)	70 (kg)
N/A	LEN
ON	OFF
999	001

Time. Maximum time in minutes allowed for a program, excluding warm-up and cooldown.

Default Weight (to user). Typical weight in lb (UNx = UNE) or kg (UNx = UNM).

Language. Display language; either LEN (English), LGE (German), LSP (Spanish), LDU (Dutch), LPO (Portuguese), LFR (French), LIT (Italian), LSW (Swedish) or LKA (Katakana).

Lockout Enable. Enables/disables lockout function.

Lockout ID. Lockout override identification number.

MAINTENANCE MODE

Your Service Representative may need to check accumulated data about the past usage of your trainer, test its display controls, or investigate error messages. For these reasons, your trainer is equipped with a Maintenance Mode. The Maintenance Mode includes all of the items available through Manager Mode, plus additional items for Service and Diagnostic use. To enter Maintenance Mode:

1.Press and hold the , and keys together.

2.A beep will sound and “MAINTENANCE SETTINGS” will scroll once across the PROFILE Window.

3.Release all keys. “SN” will display in the PROFILE Window; the associated numeric value for the parameter will display in the DISTANCE Window.

NOTE: The system will automatically exit MAINTENANCE SETTINGS if no key is pressed for 30 seconds.

The following keys are used to modify MAINTENANCE SETTINGS:

Increase and Decrease Level Keys: Display the next (Increase) and previous (Decrease) parameters. Keys will repeat if held.

Numeric Keypad: Facilitates entry of the desired value for the displayed parameter. These keys do not save the new value – see OK Key below.

OK Key: Updates (saves) the value of the displayed parameter in Flash memory. “UPDATING” will scroll once across the PROFILE Window while the update is in process. When the update is complete, the PROFILE Window will show the new value for the parameter.

NOTE: To exit MAINTENANCE SETTINGS without saving any values or settings, press the QUICK START key.

NOTE: Unless otherwise specified, the Item (parameter) name is shown in the PROFILE Window, and the value of the parameter is shown in the DISTANCE Window.

The items that you may display and change with the previous keys are:

	Lowest	Highest	Default
Item	Value	Value	Value	Meaning
SN	0	9999	N/A	Serial Number. Total Body Trainer serial number (set by factory).
DSW	1.0	99.99	N/A	Display Software. Display panel software version number (set by factory).
				NOTE: Software checksum value is displayed in CALORIES Window.
OHR	0	9999	0	Operating Hours. Total operating hours.
DST	0	9999	0	Distance. Total distance traveled in miles or kilometers, based on current UNx
				setting.
UNx	UNE	UNM	UNE	Units. UNE (English) = units of pounds, miles, feet, inches
				UNM (Metric) = units of kilograms, kilometers, centimeters
				NOTE: Current Value is shown in PROFILE Window.
TIM	5	99	99	Time. Maximum time in minutes allowed for a program, excluding warm-up
				and cooldown.

STAR TRAC S-TBTXTOTAL BODY TRAINER OWNER’S MANUAL 28