1.Identify the Front Stabilizer (3). While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).
Make sure that the Front Stabilizer is turned so the Wheels (32) are not touching the floor.
2.While another person lifts the back of the Frame (1), attach the Rear Stabilizer (4) to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).
3.While another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (86) to the Lower Wire Harness (87). Carefully pull the upper end of the Upper Wire Harness to remove any slack. While holding the upper end of the Upper Wire Harness, insert the Upright into the Frame (1). Do not pinch the Wire Harnesses.
Slide an M10 Split Washer (70) and a Frame Spacer
(83)onto each of the two M10 x 88mm Button Screws
(63).Insert the Button Screws into the Frame (1) and the Upright (2). Make sure that the concave ends of the Frame Spacers are facing the Frame. Do not tighten the Button Screws yet.
Attach the Water Bottle Holder (105) to the Upright (2) with two M4 x 22mm Screws (91).
4.The Console (5) requires four 1.5V “D” batteries (not included); alkaline batteries are recommended. Remove the battery cover from the Console. Next, insert four batteries into the battery compartments.
Make sure that the batteries are oriented as shown by the diagrams inside the battery compartments. Then, replace the battery cover.
1 | 34 |
|
| 32 |
|
|
| 32 |
|
|
|
|
|
|
|
| 3 | 1 |
|
|
|
|
|
| 29 |
| |
2 |
|
|
|
|
| |
|
|
|
| 29 |
| |
|
|
|
|
| 4 | |
|
| 29 1 |
|
| 34 | |
3 |
|
|
|
|
| |
|
|
|
| Avoid pinching | ||
|
|
|
| or damaging the | ||
|
|
|
|
| wire harnesses | |
|
| 2 |
| during this step. | ||
|
|
|
|
|
| |
|
|
|
|
| 105 | |
|
|
|
|
|
| 91 |
|
| 70 |
| 86 |
|
|
| 63 | 83 | 87 1 |
| ||
| 70 |
| ||||
4 |
| 83 |
|
|
| |
|
|
|
|
|
| |
|
|
|
|
|
| Battery |
| 5 |
|
|
|
| Cover |
|
|
|
|
|
| |
|
|
|
| Batteries |
|
5