ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the | |||
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the | |||
included allen wrenches, assembly requires a phillips screwdriver | , an adjustable | ||
wrench | , and a rubber mallet | . |
|
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers to the quantity used in assembly. Note: Some small parts may have been
M8 Split | M10 Split | M8 | Handlebar | Pedal Leg |
Washer | Washer | Washer | Washer | Washer |
Wave | Large Wave | M8 Nylon | M10 Nylon | M4 x 22mm |
Screw | ||||
Washer | Washer | Locknut | Locknut |
|
M8 x 25mm Patch |
| M8 x 52mm Button |
| M10 x 27mm |
Screw |
| Screw |
| Patch Screw |
M10 x 74mm Button Bolt |
| M10 x 75mm Carriage Bolt | ||
M8 x 45mm Button Bolt |
| M10 Bolt Set |
| |
|
| 5 |
|
|