Assembly

To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.

Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the

included hex keys, assembly requires a Phillips screwdriver			, an adjustable
wrench	, and a rubber mallet	.

As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been preassembled.

M8 Nylon	16mm Wave	19mm Wave	M8 x 25mm	M10 x 25mm
Locknut (68)–4	Washer (66)–4	Washer (71)–4	Washer (54)–8	Washer (52)–4
M4 x 19mm	M4 x 35mm
Screw (75)–4	Screw (74)–2
M4 x 50mm		M10 x 20mm Button		M10 x 35mm Shoulder
M4 x 50mm		Screw (58)–4		Screw (57)–2
Screw (76)–4
M8 x 16mm Button	M8 x 25mm Button	M8 x 35mm Button		M8 x 50mm Button
Screw (53)–5	Screw (77)–6	Bolt (67)–4		Screw (65)–2