1. | 1 |
|
| |
To make assembly easier, read the |
|
| ||
information on page 5 before you begin |
|
|
| |
assembling the elliptical exerciser. |
|
|
| |
Attach a Wheel (8) to one side of the Frame (1) |
|
|
| |
with an M10 x 35mm Shoulder Screw (57). |
|
|
| |
Attach the other Wheel in the same way. |
|
|
| |
|
|
| 1 | |
|
|
| 8 | |
|
|
| 57 | |
2. Apply a generous amount of the included | 2 |
|
| |
grease to the Pivot Axle (41). Then, insert the |
|
| ||
|
|
| ||
Pivot Axle through the Frame (1). | 23 |
|
| |
|
|
| ||
Apply a small amount of grease to a 16mm | 1 | Grease | ||
Wave Washer (66). Slide the Wave Washer | 41 | |||
|
| |||
onto the right side of the Pivot Axle (41). |
|
| ||
| 66 |
| ||
Identify the Right Upper Body Arm (37), which is |
| 37 | ||
|
|
| ||
marked with an “R” sticker. Slide the Right |
|
| 54 | |
Upper Body Arm onto the Pivot Axle (41). Attach |
|
| ||
the Right Upper Body Arm with an M8 x 25mm |
|
| 44 | |
|
|
| ||
Button Screw (77), a Pivot Axle Cover (44), and |
|
|
| |
an M8 x 25mm Washer (54). |
|
|
| |
Attach the Left Upper Body Arm (23) in the |
|
| 77 | |
|
|
| ||
same way. |
|
|
| |
3. Orient the Water Bottle Holder (6) as shown. | 3 |
|
| |
Hold the Water Bottle Holder near the Frame |
|
| ||
|
| 74 | ||
(1) and insert the Wire Harness (73) upward | 73 |
| ||
|
| |||
through the Water Bottle Holder. |
|
|
| |
Next, slide the Water Bottle Holder (6) onto the | 6 |
|
| |
|
|
| ||
Frame (1). Attach the Water Bottle Holder with |
|
|
| |
two M4 x 35mm Screws (74). |
|
|
| |
|
|
| 1 | |
| 6 |
|
| |