ProForm PFCCEX37082 Part Identification Chart, Quantity needed for assembly.Note Some small, Bolt

Page 4

PART IDENTIFICATION CHART

Use the chart below to identify the small parts used in assembly. The number in parenthesis below each part

is the key number of the part, from the PART LIST on page 14. The number after the dash indicates the

quantity needed for assembly.Note: Some small

parts may have been pre-attached for shipping. If

a part is not in the parts bag, check to see if it has been pre-attached.

M10 Nylon Locknut (54)–6

 

 

 

1/2" Nylon Locknut (9)–2

M10 Washer (71)–6

 

 

Metal Handlebar

 

 

Spacer (83)–2

 

 

 

Pedal Arm Spacer (42)–2

M16 Flat Washer (84)–2

Plastic Sleeve (53)–2

 

 

 

Pedal Bolt (8)–2

 

M4 x 38mm Screw (4)–2

 

 

 

 

M10 x 68mm Bolt (67)–4

M4 x 16mm Tapping

 

 

Screw (30)–8

 

 

 

M10 x 75mm Bolt (66)–2

Handlebar Screw (51)–4

 

 

Console Mount

M6 x 16mm Seat Screw (28)–8

M10 x 25mm Button Head

Screw (69)–1

Bolt (85)–2

 

4

 

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Read all precautions and instruc Model No. PFCCEX37082 Serial NoSerial Number Decal To operate this product, callImportant Precautions Table of ContentsBefore YOU Begin For your benefit, read this manual carefully beforeBack Right SidePart Identification Chart Quantity needed for assembly.Note Some smallM10 Nylon Locknut M10 Washer Screw M10 x 75mm Bolt Handlebar Screw Console MountAssembly Assembly requires a phillips screwdriver Two adjustable wrBase 1. Make sure that the Reed Switch Wire Rubber malletConnect the Seat Bar Wire 88 to the Handlebar Wire Make sure that the Handlebar Screws do not damage the wiresPlug the console wire into the Seat Bar Wire Wire LubricateExtension Wire 49 extending from the Upright Repeat this procedure for the Right Pedal Leg 70, not shownIdentify the Left Pedal Leg 3 by looking at Pedal Leg is mountedTo switch from elliptical crosstrainer to recumbent HOW to USE the ProformCrank HOW to Adjust the TOE Pedals HOW to Adjust the Resistance PedalsHOW to Operate the Console Move until the flywheel stopsTo reset the display, press the on/reset button Console TroubleshootingHOW to Remove the Side Shields Unscrew the three M4 x 38mm Screws 4 fromHOW to Adjust the Resistance Strap HOW to Adjust the Reed SwitchHOW to Adjust the Drive Belt HOW to Measure Your Heart Rate Conditioning GuidelinesExercise Intensity Workout GuidelinesExercise Frequency Suggested StretchesPart LIST-MODEL No. PFCCEX37082 Qty Description Key No. QtyDRAWING-Model No 81 71R0602A Limited Warranty Ordering Replacement PartsPart No R0602A
Top Page Image Contents