ASSEMBLY
Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench , a phillips screwdriver | and two adjustable | |
spanners | . |
|
1.Hold the Handlebar Post (19) near the Frame (13) as shown. Feed the Resistance Cable (6) and the Reed Switch Wire (4) into the Frame, and then slide the Handlebar Post into the Frame. Be careful not to pinch the Resistance Cable or the Reed Switch Wire. Attach the Handlebar Post with three M10 x 22mm Button Head Bolts (55) and three M10 Lock Washers (61).
The Console (5) requires one 9V battery (not includ- ed). An alkaline battery is recommended. Refer to the inset drawing. Locate the battery door on the back of the Console. Slide the battery door to the left and open it as shown. Press a battery into the bat- tery clip and insert the battery into the Console. Close the battery door and slide it to the right.
2.Make sure that there are Adjustable Endcaps (25) on the ends of the Front Stabiliser (27).
Attach the Front Stabiliser (27) to the saddle on the front of the Frame (13) with two M10 x 75mm Carriage Bolts (54) and two M10 Nylon Locknuts (44).
3.Make sure that there are Round Endcaps (15) on the ends of the Rear Stabiliser (16).
Hold the Rear Stabiliser (16) against the saddle on the rear of the Frame (13), with the square holes facing away from the saddle. Attach the Rear Stabiliser with two M10 x 75mm Carriage Bolts (54) and two M10 Nylon Locknuts (44).
1 |
|
|
| |
|
| 5 |
| |
|
| 19 |
| |
| 55 | Battery | 5 | |
| 4 | Door |
| |
6 |
|
| ||
|
|
| ||
61 | 61 | Battery |
| |
|
|
| ||
| 55 | Clip |
| |
| Battery | |||
55 | 13 | |||
|
| |||
2 |
| 25 |
| |
| 27 |
| ||
|
|
| ||
| 54 |
|
| |
25 |
|
|
| |
|
| 13 | 44 | |
3 |
|
|
| |
|
|
| 15 | |
| 44 |
|
| |
| 13 |
| Square | |
|
| Holes | ||
15 |
|
|
| |
| 16 |
| 54 | |
5