5.Have another person hold the Upright (3) near the Frame (1). Locate the wire tie (see the inset drawing) in the Upright. Tie the lower end of the wire tie to the Wire Harness (73) and to the Right and Left Extension Wires (83, 86). Next, pull the upper end of the wire tie upward out of the top of the Upright. Then, untie and discard the wire tie. Tip: Use an elastic band or a piece of tape to prevent the ends of the Wire Harness and the Right and Left Extension Wires from falling into the Upright.
Tip: Avoid pinching the wires during this step. Insert the Upright (3) into the Frame (1). Then, attach the Upright with three M8 x 16mm Patch Screws (53). Tip: Start all the Patch
Screws before tightening them.
6.The Console (4) can be operated with four 1.5V “D” batteries (not included); alkaline batteries are recommended. IMPORTANT: If the ellipti- cal exerciser has been exposed to cold tem- peratures, allow it to warm to room tempera- ture before inserting batteries into the Console. If you do not do this, the console displays or other electronic components may become damaged. Remove the the bat- tery cover and insert four batteries into the Console. Orient the batteries as shown by the markings inside the battery compartment. Then, reattach the battery cover.
Note: The Console (4) can also be operated with an optional power supply (not included) instead of batteries. To purchase a power supply, call the telephone number on the front cover of this manual. Plug one end of the power supply into the jack on the Console. Plug the other end of the power supply into an appropriate outlet that is properly installed in accordance with all local codes and ordinances.
5 |
| Wire Tie |
| 3 | 73, 83, 86 |
73 | 86 |
|
83 | 53 | |
53 | 1 | |
|
| Avoid pinching |
|
| the wires during |
|
| this step |
6 |
|
|
Batteries
4
Cover
8