ProForm PFEL6026.0 user manual

12. Identify the Left Pedal (13) and the Left Pedal	12
Leg (14), which are marked with stickers.
			13
Attach the Left Pedal (13) to the Left Pedal Leg (14)
with an M4 x 45mm Screw (108), three M4 x 14mm
Screws (104), and four Star Washers (112).
Attach the Right Pedal (not shown) to the Right
Pedal Leg (not shown) in the same way.
	112	112
		108	14
	104
		112	112
			104
13. Apply a thin film of grease to one of the Pedal Leg	13
Axles (32) and to the faces of the two Pedal Leg
Bushings (33) in the Left Pedal Leg (14).
Next, slide an M8 Washer (88) and a Pedal Leg Cover
(31) onto an M8 x 23mm Shoulder Screw (115), and	11		12
turn the Shoulder Screw a few turns into the Pedal
			88
Leg Axle (32).			31
While another person holds the front end of the Left	31		115
Pedal Leg (14) inside of the bracket on the Left Upper	88		33–Grease
Body Arm (11), insert the Pedal Leg Axle (32) into	115
both parts. Next, slide an M8 Washer (88) and a
Pedal Leg Cover (31) onto another M8 x 23mm		32
Shoulder Screw (115), and turn the Shoulder Screw a	Grease
few turns into the Pedal Leg Axle. Tighten both
Shoulder Screws.
Repeat this step on the other side of the elliptical
exerciser.			14
14. Lift the latch on the underside of the Left Pedal Leg	14
(14), and set the Left Pedal Leg on the left Crank
Bushing Sleeve (43). Release the lever, and make sure
that the Left Pedal Leg is securely connected to the
Crank Bushing Sleeve.
Connect the Right Pedal Leg (not shown) in the same	14
way.		Latch
See step 5. Tighten the M8 x 69mm Button Bolt (80)
and the two M8 x 23mm Button Screws (84).			43

15.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.

9