ProForm PFEL57907.0 HOW to USE the Elliptical Exerciser, HOW to Plug in the Power Supply

Page 12

HOW TO USE THE ELLIPTICAL EXERCISER

HOW TO PLUG IN THE POWER SUPPLY

Plug one end of the included power supply into the jack on the front of the elliptical exerciser. Plug the other end of the power supply into an appropriate out- let that is properly installed in accordance with all local codes and ordinances.

HOW TO MOVE THE ELLIPTICAL EXERCISER

Due to the size and weight of the elliptical exercis- er, moving it requires two persons. Stand in front of the elliptical exerciser, hold the upright, and place one foot against one of the front wheels. Pull on the upright and have a second person lift the rear of the ramp until the elliptical exerciser will roll on the front wheels. Carefully move the elliptical exerciser to the desired location, and then lower it to the floor.

Pull on

upright

Place

your foot

here

Lift here

Lift

here

HOW TO LEVEL THE ELLIPTICAL EXERCISER

If the elliptical exerciser rocks slightly on your floor during use, turn one or both of the leveling feet beneath the base or beneath the front stabilizer until the rocking motion is eliminated. If the elliptical exer- ciser flexes during use, turn the leveling foot beneath the center of the frame.

HOW TO EXERCISE ON THE ELLIPTICAL EXERCISER

To mount the elliptical exerciser, hold the handlebars and step onto the pedal that is in the lower position. Then, step onto the other pedal. Push the pedals until they begin to move with a continuous motion. Note:

The crank arms can turn in either direction. It is recommended that you turn the crank arms in the direction shown by the arrow below; however, for variety, you can turn the crank arms in the oppo- site direction.

Handlebars

Pedals

Crank Arm

To dismount the elliptical exerciser, wait until the ped- als come to a complete stop. Note: The elliptical exerciser does not have a free wheel; the pedals will continue to move until the flywheel stops. When the pedals are stationary, step off the higher pedal first. Then, step off the lower pedal.

12

Image 12
Contents QUESTIONS? Model No. PFEL57907.0 Serial NoCall TOLL-FREE Table of Contents Important Precautions Before YOU Begin Assembly M10 x 120mm Patch Screws Repeat this step to attach the Left HandlebarWires during this step Avoid pinchingIdentify and orient the Ramp 2 as shown Repeat this step to attach the other Pedal Page Page HOW to USE the Elliptical Exerciser HOW to Plug in the Power SupplyHOW to Move the Elliptical Exerciser HOW to Level the Elliptical ExerciserConsole Diagram Features of the ConsoleHOW to USE the Manual Mode Select the manual modePage HOW to USE a Trainer Workout Select a trainer workoutBegin pedaling to start the workout HOW to Play the FAT Blocker Game Select the Fat Blocker gamePedal to start the game Follow your progress with the displayHOW to Play the Calorie Destroyer Game Select the Calorie Destroyer gameMaintenance and Troubleshooting HOW to USE the Stereo Sound SystemHandgrip Pulse Sensor Troubleshooting Audio cable is fully pluggedExercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyPart LIST-Model No. PFEL57907.0 Qty DescriptionExploded Drawing A-Model No. PFEL57907.0 R1107A Drawing Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT