
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys and your own Phillips screwdriver , adjustable
wrench , and rubber mallet
.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the hardware kit, check to see if it has been preassembled.
|
| #8 x 1/2" | M4 x 16mm | #8 x 2" | |
M8 Hex Nylon | M10 x 22mm x | Screw | Screw | Screw | |
Locknut | 1.5mm Washer |
|
|
|
|
|
|
|
|
| |
M6 x 14mm | M6 x 18mm Patch | M8 x 19mm Patch | M10 x 15mm Patch | M10 x 27mm Patch | |
Flat Head | Screw | Screw |
| Screw | Screw |
Screw |
|
|
|
|
|
| M8 x 55mm Patch |
|
| Barrel Nut | |
| Bolt |
|
|
|
|
| M10 x 120mm Patch Screw |
| |||
|
| 5 |
|
|
|