8.Identify the Left Pedal (13). Attach the Left Pedal to the left Flex Bar (14) with an M10 x 35mm Carriage Bolt (20), an M10 Washer (99), an M10 Split Washer (117), and a Pedal Knob (15) as shown. Note: The Left Pedal can be attached in any of five positions (see HOW TO ADJUST THE PEDALS on page 10).
Attach the Right Pedal (12) in the same way. Make sure that both Pedals are in the same position.
9.Attach the Left Inner Handlebar (63) to the Upright (2) with four M6 x 16mm Tapered Button Screws (107).
Attach the Right Inner Handlebar (115) in the same way.
10.Refer to step 11. Remove the six M4 x 16mm Screws (122) and the Left and Right Handlebar Covers (109, 110) from the Console (5).
Attach the Book Holder (114) to the Console (5) with two M4 x 12mm Round Head Screws (18) as shown.
While another person holds the Console (5) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (86). Insert the excess wire harness down into the Upright (2).
Attach the Console (5) to the Upright (2) with four M4 x 12mm Round Head Screws (18). Be careful to avoid pinching the wire harnesses.
8 |
|
|
13 | 20 | 12 |
| ||
14 |
|
|
99 |
|
|
117 | 15 |
|
|
| |
9 |
| 115 |
|
| |
| 63 |
|
|
| 2 |
107 |
|
|
107 |
|
|
10 |
|
|
114 |
|
|
| 18 |
|
86 |
| 5 |
2 |
| |
|
| Wire |
|
| Harness |
18 |
|
|
8