5.Attach the Seat (12) to the Seat Frame (6) with three M6 x 16mm Screws (87).
6.Attach the Backrest (10) to the Backrest Frame (5) with two M6 x 16mm Screws (87), an M6 x 50mm Screw (69), and an M6 Flat Washer (71).
Attach the Headrest (11) to the Backrest Frame (5) with two M6 x 50mm Screws (69) and two M6 Flat Washers (71).
7.While another person holds the Upright (13) in the position shown, connect the Upper Wire Harness (35) to the Lower Wire Harness (36). Carefully pull the upper end of the Upper Wire Harness to remove any slack from the Wire Harnesses.
Turn the Knob (not shown) on the right side of the Frame (1) counterclockwise two or three turns to loosen it. Next, pull the Knob, insert the Upright (13) into the Frame, and then release the Knob. Move the Upright up and down slightly until it locks into position. Be careful to avoid pinching the Wire Harnesses (35, 36). Tighten the indicated M6 x 25.4mm Button Screw
(79)into the slot in the side of the Upright.
8.Connect the wire harness on the Handgrip Pulse Sensor (15) to the indicated wire harness on the Console (16). Insert both wire harnesses into the open- ing in the bottom of the Console. Then, insert the metal tube on the Handgrip Pulse Sensor into the opening in the bottom of the Console. Be careful not to pinch the wire harnesses.
Refer to the inset drawing. Tighten an M4 x 16mm Screw
(73)into the indicated bracket on the Console (16) and into the metal tube on the Handgrip Pulse Sensor (15).
6
5 |
|
|
12 |
|
|
6 |
|
|
87 |
|
|
| 87 |
|
6 |
|
|
11 |
|
|
| 5 |
|
| 71 | |
10 |
|
|
|
| 69 |
| 71 | 69 |
| 87 |
|
7 |
|
|
| 13 |
|
Slot |
|
|
| 35 |
|
1 | 36 |
|
79 | Knob |
|
|
| |
8 |
| 15 |
|
| |
16 |
|
|
73 | 16 |
|
| Metal |
|
| Tube |
|
73 | 15 |
|