INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (refer to page 20), follow the steps below to install the receiver and the jumper wire included with the chest pulse sensor.
1.Remove the four indicated screws from the back of the Console (16). Lift off the front of the Console.
1
16
Lift
Here
Screws 
2.Plug the jumper wire (A) into the indicated jack on the Console (16). Connect the other end of the jumper wire to the wire on the receiver (B).
Next, peel the paper off the adhesive pad on the back of the receiver (B). Orient the receiver as shown, and press it onto the Console (16) in the indicated location.
Refer to step 1 above. Reattach the front of the Console (16) with the four screws. Make sure that no wires are pinched.
2 | B |
|
|
| |
|
| Cylinder |
| 16 |
|
| Jack | A |
8