S E M B Ly, Unpacking, Tools Included

INTRODUCTION IMPORTANT PRECAUTIONS

A S S E M B LY

IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE!

WARNING

SPEAKERS CONSOLE

IPOD® DOCK

READING RACK WATER BOTTLE HOLDER

SAFETY KEY PLACEMENT GRIP PULSE HANDRAILS

CONSOLE MAST

HANDLEBAR SIDE CAP

HANDLEBAR

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

During the assembly process of the treadmill there are several areas that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have frame parts that are not tightened and will seem loose and may cause irritating noises. There should be no side-to-side play in the console masts or any forward and back play in the console assembly or handlebars. If there is any play in these areas, the treadmill has not been properly assembled. To prevent damage to the treadmill, the assembly instructions must be reviewed and corrective actions should be taken.

UNPACKING

Place the treadmill carton on a level flat surface. It is recommended that you place a protective covering on your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its side. Once the banding straps have been removed, do not lift or transport this unit unless it is fully assembled and in the upright folded position, with the lock latch secure. Unpack the unit where it will be used. The enclosed treadmill is equipped with high-pressure shocks and may spring open if mishandled. Never grab

ON/OFF SWITCH

CIRCUIT BREAKER

POWER CORD

FOOT LOCK LATCH

CONSOLE MAST BOOT

TRANSPORT WHEELS WHEEL LOCKS

MOTOR COVER

RUNNING BELT / RUNNING DECK

SIDE RAIL

ROLLER END CAP

REAR ROLLER

ADJUSTMENT BOLTS

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

hold of any portion of the incline frame and attempt to lift or move the treadmill. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!

Before proceeding, find your treadmill’s serial number and model name located to the left of the on/off power switch and power cord and enter it in the space

TOOLS INCLUDED

Screw Driver	5 mm T-wrench
13/15 mm Flat Wrench	8 mm T-wrench
5 mm L-wrench

PARTS INCLUDED

TREADMILL OPERATION

CONDITIONING TROUBLESHOOTING GUIDELINES & MAINTENANCE

provided below.

Enter your serial number and model name in the boxes below:

SERIAL NUMBER:

1 Console Assembly

2 Console Masts

2 Console Mast Boots

2 Handlebars

2 Handlebar Side Caps

2 Handlebars Side Cap Decals

3 iPod ® Dock Inserts

1 iPod ® Docking Station Rubber Plug

1 Universal MP3 Player Insert

5 Hardware Bags

1 Safety Key

1 Power Cord

1 Audio Adaptor Cable

1 Bottle of Silicone Lubricant

TROUBLESHOOTING CONDITIONING MAINTENANCE GUIDELINES

LIMITED

WARRANTY

MODEL NAME:

*Refer to the serial number and model name when calling for service.

*Also enter this serial number on your Warranty Card.

If you have questions or if there are any missing parts, contact Customer Tech Support.

Contact information is located on the back panel of this manual.

For a complete exploded diagram, visit us at www.horizonﬁtness.com

LIMITED WARRANTY &

T900_Treadmill_Rev.1.3.indd 6-7

6/26/07 3:50:11 PM