Part Descriptions

A S S E M B LY

I N S T R U C T I O N S

Step 2c

F R A M E A S S E M B L Y

Press two (CJ)’s into (8). Attach (10) to (CH), then slide (CH) through (1) and attach to (9). Next, slide one side of (8) onto (CH), then slide the other side of (8) through (6) and secure. Attach (13) to (8) and secure. Attach two (CM)’s to (5), and slide (11) into (5). Attach (12) to

(5). Secure (CN) to (8) and attach (CP) to (CN). Hand tighten bolts only, they will be tightened later.

1 - Weight Cage

5 - Seat Frame Assembly

6 - Seat Support Mount

8 - Arm Support Assembly

9 - Range of Motion

10 - Cam Assembly Large

11 - Seat Adjuster

12 - Latch Assembly

13 - Aluminum Cap (Red Anodized)

Hardware Descriptions

D - 3/8”-16 x 1 1/4” Flat Head

R - Set Screw

CF - 3/8” x 2” Open Roll Pin

CG - Aluminum Cap

CH - 1.00 Dia. 13.609 Shaft

CJ - 1” OD Oilite Bushing

CK - Adjustment Spring

CL - 1/4” OD Pivot Shaft

CM - EZ-Glide Sleeve

CN - 1/2” Short Pull Pin

CP - Pull-Pin to Chain Link Connector CQ - 2 x 4 End Cap

CR - 1/4” C-Clip

DR - 3/8” Flat Head Cap (Red Anodized)

	HOIST	R
Page 11		2601 Assembly
	FITNESS SYSTEMS