A S S E M B LY
I N S T R U C T I O N S
Step 2e
F R A M E A S S E M B L Y
In this step start by pressing (17) in (1), then place (18) over (17) and insure holes are lined up. Next slide in two (16)’s in (1). Slide fifteen (19)’s and one (20) onto both (16)’s. Make sure the weight stack and its guide rods are sitting level and bolt the tops of (16) to (1). Attach (14) to
(21)and secure (21) to (20),then press two (31)’s in each of the three (22)’s and slide on three (22)’s on to (21). Next attach (14) to (1). Attach the bigger end of (CT) to (21) and the other end to (15). Wrench tighten
bolts including all previously hand tightened bolts.
Part Descriptions
1 - Weight Cage
14 - Add on Rods
15 - Weight Selector Pin
16 - Guide Rod
17 - Guide Rod Bushing
18 - Weight Bumpers
19 - 20 LB Intermediate Weight
20 - 15 LB Aluminum Top Plate
21 - Center LH BRK (Add on)
22 - 5 LB Add on Weight
31 - Bushing for Cast Add on Weight
Hardware Descriptions
E -
F -
G -
H -
AA- 1/2” Lock Washer AE - 3/8” Flat Washer AF - 3/8” Lock Washer AG - 5/16” Flat Washer AH - 5/16” Lock Washer AJ - 3/8” Lock Washer AK - 3/8” Flat Washer CT - Selector Pin Lanyard CV - Guide Bearing (Tall) CW - Guide Bearing (Short)
| HOIST | R | |
Page 15 | 2601 Assembly | ||
FITNESS SYSTEMS |