Suunto t1 manual Stopwatch

Page 21

After switching to Training mode, Suunto t1 displays two bars while it is seeking the HR belt signal.

Instead of your heart rate, "00"

is shown in the center of the display if no heart rate belt is found.

3.2. Stopwatch

The stopwatch is activated by short pressing the START button in Training mode. It can be seen in the top row in Training mode. The information from the training that you time with the stopwatch, such as heart rate and calorie consumption, is stored and can later be seen in Totals and Summary.

Therefore, you should activate the stopwatch, and ensure you have a heart rate reading, whenever you start a training session.

	Pressing the	Pressing the
	START/STOP button
		START/STOP
	starts the stopwatch
		button again
	and calculation of
		stops the
	amount of calories
		stopwatch.
	consumed.

19

Image 21

Contents Page Time mode Training mode Welcome Page Page Getting Started Activity class act class Setting up Suunto t1Activity description Suunto t1 at a glance Time mode Training mode Settings menuSummary Totals Time modeLight Training modeSettings Symbol Setting Options Putting on the heart rate transmitter belt Before TrainingHeart rate signal troubleshooting Heart rate limit settings Target Heart rate zone settingsAbove zone 3 Zone 3 Zone 2 Zone Below zone Heart rate Default setting Main benefit ZoneTime/date settings General settingsPersonal settings Training Connecting your Suunto t1 to the heart rate transmitter beltStopwatch Page Training summary After TrainingTraining totals Suunto Training World General instructions Care and MaintenanceChanging the strap length Water resistanceReplacing the battery Replacing the battery of the Suunto t1 Page General Technical SpecificationsDisclaimers Intellectual PropertyLimits of liability and ISO 9001 compliance After sales service Disposal of the Device Page TWO Year Warranty Page Copyright Customer Service ContactsSuunto Oy 5/2006