JVC GVT0119-001C, CA-HXZ77D Setting the Clock, To check the clock time while playing a source

English

Getting Started (continued)

Setting the Clock

You can set the clock when the unit is either turned on or off (on standby).

On the front panel ONLY:

1 Press CLOCK/TIMER.

5 Press SET/DISPLAY to finish setting the clock.

“CLOCK OK” appears on the display, then the built-in clock starts.

To check the clock time while playing a source

Press and hold SET/DISPLAY.

•Each time you press and hold the button, the source indication and the clock time alternate on the display.

To adjust the clock again

If you have set the clock before, press CLOCK/TIMER repeatedly until the clock setting mode is selected.

•Each time you press the button, the clock/timer setting modes change as follows:

	“0:00” appears on the display with the hour digit flashing.				DAILY			TIMER			REC
			(Daily Timer on/off)				(Daily Timer setting)			(Recording Timer on/off)
					Canceled				Clock		TIMER
									setting	(Recording Timer setting)
						(The hour digits start flashing.)
2	Turn ¢ / 4 to adjust the hour.			When you unplug the AC power cord or if a power
				failure occurs
	• As you turn the control, the hour digit changes continuously.
		The clock loses its setting and resets to “0:00.” If this happens, set
		the clock again.

The clock may gain or loss 1 to 2 minutes per month

3	If this happens, set the clock again.
	Press SET/DISPLAY to set the hour.

The minute digit starts flashing.

•If you want to change the hour again, press CANCEL/DEMO. The hour digit starts flashing again.

4 Turn ¢ / 4 to adjust the minute.

• As you turn the control, the minute digit changes continuously.

13